We apologise for any inconvenience our phones are currently down please send emails to info@shoprvparts.com.au in the interim
Contact Us: info@shoprvparts.com.au
We apologise for any inconvenience our phones are currently down please send emails to info@shoprvparts.com.au in the interim
Contact Us: info@shoprvparts.com.au
From replacement fabric to mounting brackets and poles, we have a wide selection of high-quality caravan awning parts to choose from.
Whether you're a seasoned caravanner or just starting, our awning accessories and parts are perfect for maintaining and improving your awning. With our wide range of options, you can find everything you need to customize and care for your awning to suit your individual needs and preferences. So, whether you're looking for replacement parts or new accessories, we have you covered. Browse our full selection below from brands like Dometic, Navigator and Carefree, and enjoy the convenience and comfort of your caravan awning for years to come.
To install: Start to Splay the rivet end with a hole punch (or bevel the end of an old screw driver to 45degrees). Once started to splay, it will continue with taps by a hammer, while the rear is against something solid.
Fitting Instructions:
- Fully extend the awning out.
- Undo the screw holding the cap to the arm. DO NOT BUMP THE LEVER!
- Slide the remote lock down the channel which will now be exposed.
- Put the cap back onto the arm.
- Carefully slip the top of the remote over the ratchet lever.
- More details if needed are on page 8 of the service manual.
Note: Suits Carefree Fiesta / Spirit FX Awnings. Carefree Part Number: 901046W
Carefree awning Lift Handle. Lift handle to lengthen and lock arms for Fiesta and SPIRIT or Simplicity Carefree rollout awnings. These hold the awning arms at the required length when awning is in use.
The wide curved face helps to reduce wear on the awning fabric, while also featuring an industry first utility slot down each side. This allows you to easily hang screens, side panels and other awning accessories.
The Carefree rafter also features 2 different methods of attaching to the roller tube, so you can choose which best suits you.
The first method uses the standard pin which slots into a hole which you must drill into your awning barrel.
For those who don't want to drill into their awning barrel there is also an included mounting cradle which can be used to secure the rafter instead.
This rafter has a larger curve than most standard curved rafters which will provide greater tension and awning stability but could lead to fabric stretching if used for prolonged periods.
Features:
- Sturdy construction
- Powder-coated finish
- Wide curved face reduces wear on fabric
- Utility slots on each side for screens or other accessories
- Two different mounting options
Note: Suit Carefree, A&E, Dometic and many other awnings. NOT suitable for Fiamma Awnings.
Carefree's new Straight Rafter is a straight rafter designed to add rigidity and further support to your awning. Installing the Straight Rafter is simple and easy. The rafter end simply hooks directly to your awning rail and with the quick turn of the locking knob, the rafter quickly extends to fit snugly against the roll bar. The RV bracket needs to be drilled in against the wall side to fit.
The Straight Rafter also includes an industry first utility slot to quickly hang side blockers, side panels or other awning accessories.
Carefree's new Straight Rafter is a straight rafter designed to add rigidity and further support to your awning. Installing the Straight Rafter is simple and easy. The rafter end simply hooks directly to your awning rail and with the quick turn of the locking knob, the rafter quickly extends to fit snugly against the roll bar. The RV wall bracket needs to be drilled in against the wall side to fit.
The Straight Rafter also includes an industry first utility slot to quickly hang side blockers, side panels or other awning accessories.
Note: Suit Carefree, A&E, Dometic and many other awnings. NOT suitable for Fiamma Awnings.
Features:
- Cradle head to support awnings with roll bars
- Stabiliz'r Grip head to allow securing to a box awning
- Poles feature crank knobs to secure the pole to the adjusted height
- Comes with stakes and straps to secure the poles to the ground and awning.
- Designed for quick set up, under 5 minutes!
Important!
When using this kit with Altitude awnings, or any powered awning, ensure that the awning's power is switched OFF prior to installation! This prevents any sensors the awning has from activating and causing it to retract. If you need to adjust the awning pitch after set up, loosen the pole's straps and lower before adjusting.
Once you roll up your awning, the pivoting head receives the roller & support it, eliminating weight stress & potential bowing in the centre of your awning roller. The awning supports will not damage the awning fabric. Recommended for use on flat walls (of RV's) & for awning widths of 16ft or greater.
The Navigator Awning Buddy has two awning straps that are made to fit into the sail track on caravan awnings and most 4WD awnings.
The wide curved face helps to reduce wear on the awning fabric, while also featuring an industry first utility slot down each side. This allows you to easily hang screens, side panels and other awning accessories.
The Carefree rafter also features 2 different methods of attaching to the roller tube, so you can choose which best suits you.
The first method uses the standard pin which slots into a hole which you must drill into your awning barrel.
For those who don't want to drill into their awning barrel there is also an included mounting cradle which can be used to secure the rafter instead.
This rafter has a larger curve than most standard curved rafters which will provide greater tension and awning stability but could lead to fabric stretching if used for prolonged periods.
Features:
- Sturdy construction
- Powder-coated finish
- Wide curved face reduces wear on fabric
- Utility slots on each side for screens or other accessories
- Two different mounting options
Note: Suit Carefree, A&E, Dometic and many other awnings. NOT suitable for Fiamma Awnings.
Carefree's new Straight Rafter is a straight rafter designed to add rigidity and further support to your awning. Installing the Straight Rafter is simple and easy. The rafter end simply hooks directly to your awning rail and with the quick turn of the locking knob, the rafter quickly extends to fit snugly against the roll bar. The RV bracket needs to be drilled in against the wall side to fit.
The Straight Rafter also includes an industry first utility slot to quickly hang side blockers, side panels or other awning accessories.
Carefree's new Straight Rafter is a straight rafter designed to add rigidity and further support to your awning. Installing the Straight Rafter is simple and easy. The rafter end simply hooks directly to your awning rail and with the quick turn of the locking knob, the rafter quickly extends to fit snugly against the roll bar. The RV wall bracket needs to be drilled in against the wall side to fit.
The Straight Rafter also includes an industry first utility slot to quickly hang side blockers, side panels or other awning accessories.
Note: Suit Carefree, A&E, Dometic and many other awnings. NOT suitable for Fiamma Awnings.
Features:
- Cradle head to support awnings with roll bars
- Stabiliz'r Grip head to allow securing to a box awning
- Poles feature crank knobs to secure the pole to the adjusted height
- Comes with stakes and straps to secure the poles to the ground and awning.
- Designed for quick set up, under 5 minutes!
Important!
When using this kit with Altitude awnings, or any powered awning, ensure that the awning's power is switched OFF prior to installation! This prevents any sensors the awning has from activating and causing it to retract. If you need to adjust the awning pitch after set up, loosen the pole's straps and lower before adjusting.
Once you roll up your awning, the pivoting head receives the roller & support it, eliminating weight stress & potential bowing in the centre of your awning roller. The awning supports will not damage the awning fabric. Recommended for use on flat walls (of RV's) & for awning widths of 16ft or greater.
The Navigator Awning Buddy has two awning straps that are made to fit into the sail track on caravan awnings and most 4WD awnings.
© 2022 Shop RV Parts Australia. All Rights Reserved
